3/6 Lowering Kit for 1983-1997 Ford Ranger 2WD 4-Cylinder - Coils / Flip Kit

Product Description

Description:

3-inch front / 6-inch rear lowering kit for 1983–1997 Ford Ranger 2WD 4-Cylinder gasoline pickups. Shocks sold separately.

Front 3 in / rear 6 in; 4-Cylinder; No shocks included

Includes:

• Front lowering coil springs (pair)
• Rear axle flip kit (saddles and spring plates)
• Rear lowering shackles (pair)

Vehicle Fitment: 

• 1983-1997 Ford Ranger 2WD

Fitment Notes:

• Fits 1983–1997 Ford Ranger 2WD gasoline pickup models with a 4-Cylinder engine.
• 4-Cylinder engine application only. See the related kit for the other engine option.
• Does NOT fit 4WD models.
• Lowering amounts are based on standard factory ride height. Factory-lowered suspension, including Splash models, worn springs and vehicle equipment can change the measured reduction.
• Professional alignment required after lowering. Camber/caster correction bushings may be needed and are not included. Consult a shop experienced with Ford Twin I-Beam suspension before installation.
• U-bolts are not included. See the related products for the correct 1983–1997 Ranger U-bolt set.
• Extended-cab models with a two-piece driveshaft may require carrier-bearing correction if driveline vibration occurs after lowering.
• Shocks are not included. See the related kit option with front and rear lowering shocks.
• A C-notch is recommended at a 6-inch rear drop. A C-notch is not included. See the related kit option with a C-notch.

Related SKUS (if any):

1983, 1984, 1985, 1986, 1987, 1988, 1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997 Ford Ranger 2WD

83, 84, 85, 86, 87, 88, 89, 90, 91, 92, 93, 94, 95, 96, 97 Ford Ranger 2WD